...
- SSID - SSID of choice
- Network security type: WPA2 Enterprise
- WPA type: Set to either Auto or WPA2
- WPA encryption: Set to either Auto or AES
- RADIUS server IP - 192.168.9.1
- RADIUS server port - 1812
- RADIUS server secret/password - Password chosen in clients.conf for this particular NAS
- Secure password - Choose a secure password for accessing the NAS web (or other) interface. It is important as it controls access to the wireless security settings, and the web (or other) interface is reachable by supplicants connected to the network.
- Clients isolation - If enabled, prevents connected supplicants from talking to each other/seeing each other's traffic. Can improve security if there is either only one NAS installed or each NAS is in a separate broadcast domain (and there is no other device connected, e.g. through wired network, in the same broadcast domain), at the expense of not allowing connected supplicants to communicate directly with each other (e.g. SSH into each other, etc.)
- IP address - IP address needs to match IP mentioned in clients.conf
- Disable DHCP server
- Some models: Reauthentication period - Specify to something equal to or greater than the Session-Timeout specified in /etc/freeradius/3.0/sites-available/default. Some NASes interpret 0 as disabling re-authentication, and might then also ignore any value mentioned by the FreeRADIUS Session-Timeout / Termination-Action attributes.
- Some models: WPA2/RSN preauthentication '@@@'- It is suggested to try and disable this feature in case issues are encountered such as mentioned in the "General information" page under Misc. Information point 9.
- Some models: Operation mode - Some NASes have an Operation mode setting, which pre-sets/locks some settings to defaults that are appropriate for different kinds of uses, e.g. "DSL Router", "Wireless Router", "Wireless Access Point". This varies by model, but usually something like "Wireless Access Point" is a good first choice, if available, alternatively "Wireless Router"
TP-Link Archer C20 v4 00000004
In this model, the "Reauthentication period" setting is not available, but the router does honor the timeout specified by the RADIUS server. Operation mode can be set to "Access Point". All other settings should be set as mentioned above. This is a dual band router and some settings need to be set in two places, once for each SSID.
TP-Link TD-W8968 V4 0x00000001
In this model, the "Reauthentication period" setting is available as "Network Re-auth Interval", and the router also does honor the timeout specified by the RADIUS server, and follows whichever is smaller. Setting the setting to zero causes the feature to be disabled and the timeout specified by the RADIUS server to also be ignored. Operation mode can be set to "Wireless Router Mode". All other settings should be set as mentioned above.
TP-Link TL-WR740N v4 00000000
In this model, the "Reauthentication period" setting is not available, and the router does not honor the timeout specified by the RADIUS server. The hostapd daemon running on this router supports the feature and works in a similar way as in the above TP-Link TD-W8968 V4, but no option to configure it is available in the web interface, and hostapd is run with this setting set to 0. Judging by the source code of this (very old) version of hostapd, it is believed (but not tested) that this means, once authenticated, the router might allow the supplicant to continue being part of the network for up to twelve hours without querying the RADIUS server again. A fix is possible to make hostapd run with its default setting of 3600 seconds, but is out of the scope of this wiki page. '@@@'RSN Using a similar fix it is believed to be possible to disable RSN pre-authentication. No operation mode setting is available. All other settings should be set as mentioned above.
...