Preparing a RAID system of 2 disks and 2 partitions

In the following examples we are going to use sdb and sdc for the disc to use in the RAID. Adapt it to your situation.

Create the partitions

fdisk /dev/sdb

• p check the partition table
• n create partition (ex +128M)
• t filesystem
• a bootflag
• w write 

Set the RAID1 system on the 2 partitions

mdadm --create /dev/md0 --level=1 --raid-devices=2 /dev/sdb1 /dev/sdc1

mdadm --create /dev/md1 --level=1 --raid-devices=2 /dev/sdb2 /dev/sdc2

Check the RAID-DEVICES

cat /proc/mdstat

Make the file system

mkfs.ext3 /dev/md0

mkfs.ext4 /dev/md1

Mount the disks

mkdir /mnt/md0

mkdir /mnt/md1

mount /dev/md0 /mnt/md0/

mount /dev/md1 /mnt/md1/

Copy the data of Home

cd /home

tar c * | tar x -C /mnt/md1

Find the UUID of the 1st partition

blkid

/dev/md1: UUID="3968404e-6571-4671-a157-9113a9f2fcba" TYPE="ext4"

Make md1 be the home directory

emacs /etc/fstab

# /home was on /dev/sda9 during installation

UUID=3968404e-6571-4671-a157-9113a9f2fcba /home ext3 defaults 0 2  

Add new Hard drive

Connect the new hard disk and boot a system.

This will create on the new drive a partition table identical to the one of the existing working drive (this will also copy GRUB).

(Assuming that /dev/sda is the existing working drive and /dev/sdb is the newly added drive)

{code}

dd if=/dev/sda of=mbr.bin bs=512 count=1

dd if=mbr.bin of=/dev/sdb bs=512 count=1

{code}

Now, check the status of the RAID devices to see the device numbers

{code}

cat /proc/mdstat

{code}

Now, add the appropriate partition of the new drive to the RAID devices, repeat for each RAID device.

{code}

mdadm --manage --add /dev/md0 /dev/sdb1

{code}